Scoliosis & Spinal Deformity Surgery can correct abnormal spinal curves to relieve pain symptoms and lengthen a person’s life

Through the placement of hooks, rods and screws, a spinal curve can be corrected and stabilized. A fusion often follows scoliosis surgery, in order to maintain the correction permanently.

Scoliosis is not the result of an injury and usually appears without cause. It can be inherited and it usually affects more women than men. In the case of most spinal curves, the spine is not only bent but also twisted like a bent corkscrew. Some cases of scoliosis are not serious. Over time, if a curve worsens, surgery may be required to correct the curve and prevent pain and worsening deformity. In extreme cases, if the curve is not corrected, the spinal deformity can place pressure on internal organs, which can shorten a person’s life expectancy.

During scoliosis surgery, the surgeon may use special instruments that attach onto various vertebra segments. These surgical rods are the adjusted to “de-rotate” the twisted and bent corkscrew spine. Decades ago, Harrington Rods (the “first-generation” of instrumentation) were used to surgically straighten the spine. However, this technique did not untwist or correct the spine. Today, there are “fourth-generation” techniques to improve corrections, minimize levels fused and minimize the need for post-operative bracing.

Spinal fusion

Unusual movement at a vertebral segment will probably result in pain, especially if the person already has or displays symptoms of degenerative disc disease, fractures, scoliosis or a weak spine. This movement may require a discectomy, and subsequently, a lumbar interbody fusion. Anterior and posterior fusion techniques can be performed in the neck and the low back.

Not all patients who have spinal problems need spine surgery. They can be managed with microscopic decompression or minimally invasive techniques. Spinal fusion is reserved for patients who have spinal instability, spinal deformity or painful degenerative pain. Obviously, this is only after a patient has failed all conservative measures.

In fusion surgery, the goal is to cause bone graft to grow between two vertebrae and stop the motion at a particular segment by adding bone graft to it. This results in one long bone rather than two separate vertebrae. Anterior and posterior lumbar fusions may be done separately or can be used together for the most severe problems of the cervical (neck), thoracic (chest level) and lumbar spine (low back). Your spinal surgeon will help you decide which technique is right for you.